Parts manufactured through power metallurgy (PM) typically contain pores that can be detrimental to the final mechanical properties. This paper explores the merits of 3D X-ray computed tomography over traditional microscopy for the characterization of the evolution of porosity in metal injection moulding (MIM) and direct powder rolling (DPR) products. 17-4 PH stainless steel (as-moulded, as-debound and sintered) dog-bone samples produced via MIM and Ti-HDH strips (as-rolled and sintered) produced via DPR and were analysed for porosity. 3D micro-focus X-ray tomography (XCT) analysis on specimens from both processes revealed spatial variations in densities and the existence of characteristic moulding and roll compaction defects in agreement with traditional microscopic microstructural analysis. It was concluded that micro-focus XCT scanning can be used to study MIM and DPR parts for the characterization of the amount, position and distribution of porosity and other defects. However, the majority of the sub-micron sized pores could not be clearly resolved even at the highest possible instrument resolution. Higher-resolution scans such as nano-focus XCT could be utilized in order to fully study the porosity in MIM and DPR parts.
Reference:
Muchavi, N.S., Bam, L., De Beer, F.C. et al. 2016. X-ray computed microtomography studies of MIM and DPR parts. Journal of the Southern African Institute of Mining and Metallurgy, vol. 116(10): 973-980. doi.org/10.17159/2411-9717/2016/v116n10a13
Muchavi, N. S., Bam, L., De Beer, F., Chikosha, S., & Machaka, R. (2016). X-ray computed microtomography studies of MIM and DPR parts. http://hdl.handle.net/10204/9448
Muchavi, Noluntu S, L Bam, FC De Beer, Silethelwe Chikosha, and Ronald Machaka "X-ray computed microtomography studies of MIM and DPR parts." (2016) http://hdl.handle.net/10204/9448
Muchavi NS, Bam L, De Beer F, Chikosha S, Machaka R. X-ray computed microtomography studies of MIM and DPR parts. 2016; http://hdl.handle.net/10204/9448.
